"District 5 Warehouse" Topic
1 Post
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please remember not to make new product announcements on the forum. Our advertisers pay for the privilege of making such announcements.
For more information, see the TMP FAQ.
Back to the SF Discussion Message Board Back to the Terrain and Scenics Message Board
Areas of InterestGeneral
Science Fiction
Featured Hobby News Article
Featured Link
Featured Ruleset
Featured Showcase Article Need some low-pressure clamps?
Featured Profile Article Thanks to the generosity of TMP readers, there has been much progress in building a new home for our staff editor and her family, evicted from their home.
|
| Tango01 | 22 Jun 2017 2:53 p.m. PST |
"The District 5 Warehouse can be assembled in shorter / longer version using walls from different Micro Art Studio kits or with smaller amount of the ones included. It has four wall sections with small entrance for S1 and S2 silhouette models and two wall sections with wide entrance that is big enough for everything up to S4. The main gates are 10cm / 4 high and 8cm / 3,5 wide. Any Infinity Silhouette will fit in them when they are fully open.Theyfre movable and can be opened as wide as you wish. Ground and first floor walkways, as well as two ladders, are in the set. The first floor walkway is wide enough to fit a 40mm base and itfs threshold is high enoigh to give Total Cover to prone models. The inner ground floor supports are bulky enough to give Partial Cover to S2 models even if the District 5 Warehouse is empty. The outer supports can give Partial Cover to S2 and fit the District 5 Staircase…"
Main page
link
Amicalement
Armand
|
|
