"question about axis & alllies miniatures kettenkrad" Topic
6 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please be courteous toward your fellow TMP members.
For more information, see the TMP FAQ.
Back to the WWII Discussion Message Board Back to the WWII Models Review Message Board
Areas of InterestWorld War Two on the Land
Featured Hobby News Article
Featured Link
Top-Rated Ruleset
Featured Book Review
Featured Movie Review
|
green beanie | 24 Jun 2016 7:01 a.m. PST |
any one know what scale the A&A German kettenkrad is? I know some of the later items were 15 mm, but some of the early stuff was all over the place. Thanks for your help. |
martin goddard | 24 Jun 2016 9:02 a.m. PST |
You might put it alongside the Peter Pig 15mm kettengrad. Or you coukd say the measurement her and I can measure a PP one? martin |
Upuaut72 | 24 Jun 2016 2:18 p.m. PST |
I have a few of them. They are from the later sets that had (in theory) 15mm vehicles. They do seem to be about right, visually at least, for 15mm. I measured one: width; outside of tracks to outside of tracks = 10mm height; bottom of tracks to handlebars 10mm over all length, from front of tyre to back of the bodywork = 31mm. |
green beanie | 25 Jun 2016 5:49 a.m. PST |
Thank you Upuant72. Do you recall the sets they were from? I am thinking of getting some from Ebay. |
Marc33594 | 25 Jun 2016 6:53 a.m. PST |
Very close to the Flames of War ones. width 9mm height 10mm length 30mm Points of measure might account for difference but dont think you could tell on table |
Upuaut72 | 25 Jun 2016 10:13 a.m. PST |
They were part of the "Early War" set, and the "North Africa" set. Same model was used for each, just the paint job is different, German grey for EW, or desert on the NA one. |
|