Sure!
I'm using music wire from K&S Engineering.
ksmetals.com/17.html
What you see is product #498 .015" x 36". I *think* it's sold in bundles of five three foot pieces. It's fairly rigid, but has some flex.
I laboriously cut each piece by hand to fit on the model. Sometimes I cut it too short and have to start another piece. (The table is littered with very short fragments of wire that I really need to clean up with a good magnet.)
The wire is attached using CA cement. I experimented with using two part epoxy, but the results were about the same as the CA for three times the work.
I typically paint the wire black after installation using a fine flat edge brush and black paint – either Vallejo or any brand of acrylic craft paint. (It's the same black used on the hull, if I'm painting the hull black.)
The back of my head says I should spray paint it all black as a group and then cut to length. I'll have to try that in the future.
Thanks for asking – and don't hesitate to ask if you have other questions.