"Easy way to disassemble Reaper Bones minis?" Topic
1 Post
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please don't make fun of others' membernames.
For more information, see the TMP FAQ.
Back to the Conversions Message Board
Areas of InterestGeneral
Featured Hobby News Article
Featured Link
Featured Showcase Article
Featured Profile Article Time to replace the equipment again!
Featured Book Review
|
| Zephyr1 | 04 Mar 2015 3:49 p.m. PST |
I've noticed that many Reaper Bones minis are actually multi-part, but can't figure out if they are glued together or not. If glued, what kind was used? Thinking of using a solvent if possible, as I'm afraid that using force in some cases would be a bad idea.
In addition to converting and reposing, some of them need to be taken apart to reach the hard-to-paint places.
Also wondering if the original metal minis were also multi-part.
Thoughts? Thanks! |
| Warlord | 04 Mar 2015 4:12 p.m. PST |
I have actually pulled them apart very carefully with no problem if they are glued together, however I can understand your concern of breaking them. Have you tried placing them in hot water, re positioning them and then in cold water and they stiffen right back up in the new pose – works great. I am not sure what glue they are using but if you use an instant glue on the bones it works VERY well. |
|
goes to sea with the Terrain Mat.