"Making open-faced moulds for our robots Kickstarter..." Topic
3 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please remember that some of our members are children, and act appropriately.
For more information, see the TMP FAQ.
Back to the SF Discussion Message Board Back to the Moldmaking and Casting Message Board Back to the Not found! Message Board
Areas of InterestGeneral Science Fiction
Featured Hobby News Article
Featured Link
Featured Ruleset
Featured Showcase ArticleNeed an armored car in 15mm or 20mm, but don't have a lot of cash?
Featured Profile ArticleThe Editor takes a virtual tour of Reaper's new offices.
Current Poll
Featured Book Review
Featured Movie Review
|
Lovejoy | 01 Nov 2014 4:00 p.m. PST |
link One of our project's Stretch goals was for wrecked robot models, and we've been making some simple moulds to cast them in resin – there's a step by step break down at the link above, if you're interested…
|
shaun from s and s models | 03 Nov 2014 3:50 a.m. PST |
|
Lovejoy | 03 Nov 2014 1:48 p.m. PST |
Cheers! They cast pretty well too: link
|
|