Help support TMP


"The new Chinese versions of Light Armoured Vehicles." Topic


3 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Please do not post offers to buy and sell on the main forum.

For more information, see the TMP FAQ.


Back to the Modern Discussion (1946 to 2013) Message Board


Areas of Interest

Modern

Featured Hobby News Article


Featured Recent Link


Top-Rated Ruleset


Featured Showcase Article

Lemax Christmas Trees

It's probably too late already this season to snatch these bargains up...


Featured Movie Review


636 hits since 17 Sep 2014
©1994-2024 Bill Armintrout
Comments or corrections?

Tango0117 Sep 2014 10:17 p.m. PST

"Chinese Defense Industry unveils at AAD 2014, a new version of the Dongfeng-Mengshi with an extended chassis and fitted with armour to increase protection and payload. The vehicle can carry a total of 10 military personnel including driver and commander.

At AAD 2014, two version versions of the vehicle are displayed on the booth of the Chinese Company Dongfeng. One version in 4x4 configuration and the second version using a 6x6 chassis.
The driver is seated at the front of the hull on the left with the vehicle commander to his right. Both are provided with a bulletproof windscreen to their front, which is covered by an armoured shutter, hinged at the top, when the vehicle is in combat areas. Two large doors are available on each side of the vehicle. For the rear door, the upper part of which opens to the upwards while the lower part folds down to form a step. Inside the vehicle, the soldier compartment are equipped with mine blast resistant seats . A total of four seats are available at the front of the vehicle and six at the rear. There is a large door in the rear that opens to the left…"

picture

Full article here
link

Amicalement
Armand

Lion in the Stars18 Sep 2014 1:25 p.m. PST

How do you say "stretched humvee" in Chinese?

Tango0118 Sep 2014 1:40 p.m. PST

(smile)

Amicalement
Armand

Sorry - only verified members can post on the forums.