I've recently added this to my kickstarter, but I would like to get some feed back from gamers now I have made my first test-cast
The parts:
Total of 12 components… well that's counting the rockets sprues as one piece for each. It may be more accurate to say 26 components, but it depends how you do the assembly.
My intention is that the rockets are glued to the rails whilst attached to the sprue
Cutting them off with a knife is a bit tricky, might be easier to do it with a Dremel saw (and dust mask)
The other side rockets added. The underside of the launch rails is a bit of a mess, but should be hidden.
I need to redesign the moulds for the supports, they are a bit hard to cast at the moment.
The wheel attaching points are just chunky enough for solidity. The undercarriage is lacking, but it seems to me that few wargames care for underside details, please tell me if I am wrong.
The pins for the rail supports are a bit too flimsy.
So what needs improving? I can re-print a few components in the next print run (but redoing everything would be a bit expensive). I can also rework the moulds to reduce flash and airbubbles.
Candid opinions please.
Cheers
~ Bob
MadBobMiniatures