"All Quiet Drones Assembly" Topic
7 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please remember that some of our members are children, and act appropriately.
For more information, see the TMP FAQ.
Back to the Victorian SF Message Board
Areas of Interest19th Century Science Fiction
Featured Hobby News Article
Featured Link
Featured Ruleset
Featured Workbench ArticleBuilding a flying two-turret monitor from scratch, inspired by Space: 1889.
Featured Book Review
|
Please sign in to your membership account, or, if you are not yet a member, please sign up for your free membership account.
Lucius | 22 Aug 2014 1:56 p.m. PST |
I got a package of drones today, and they don't have any assembly instructions. There is a large square tab on what I assume is the bottom piece. Is this supposed to be removed? And are there assembly instructions anywhere? |
tberry7403 | 22 Aug 2014 2:25 p.m. PST |
I know of no assembly instructions for drones. Check out the following TMP posting that has closeups of assembled drones: TMP link Hope this helps, Tim |
Lucius | 22 Aug 2014 3:31 p.m. PST |
Thanks. Unfortunately, all the photos are pretty dark on the underside, and I can't tell whether the tab stays, or needs to be filed down. |
tberry7403 | 22 Aug 2014 3:42 p.m. PST |
Don't remember a tab. Try looking here on their website: link Scrolling over the image gives you an expanded image. Tim |
Lucius | 22 Aug 2014 5:00 p.m. PST |
I guess it is flash. One of the three doesn't have it, so it gets removed. Constructive criticism from a guy who has dropped $400 USD on this game – an assembly schematic, or even a close-up photo on the box would be nice. Ditto on the command tank blister. |
Lucius | 22 Aug 2014 5:19 p.m. PST |
O.k. – confused again. When you flip the top "turret/head" over, there is a cutout/indentation that lines up with the three grooves on the bottom half of the head. That is where the three legs are supposed to be. But there is only one cutout, not three. So are there supposed to be two more cut outs/indentations, which line up with the grooves on the bottom, or is the single cutout/indentation on the bottom of the "head" supposed to be for something else? |
tberry7403 | 23 Aug 2014 8:11 a.m. PST |
I took it to be an "alignment" mark so you have the two holes (for the gun and reaper limb) facing the front of the drone. |
|