Help support TMP


"question airportable rubber fuelling tanks" Topic


11 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

In order to respect possible copyright issues, when quoting from a book or article, please quote no more than three paragraphs.

For more information, see the TMP FAQ.


Back to the Modern Aviation Discussion (1946-2015) Message Board

Back to the Modern Discussion (1946 to 2015) Message Board


Areas of Interest

Modern

Featured Hobby News Article


Featured Link


Featured Ruleset


Featured Showcase Article


Featured Profile Article

Scenario Ideas from The Third World War

Personal logo Editor in Chief Bill The Editor of TMP Fezian harvests scenario ideas from The Third World War.


1,186 hits since 26 May 2013
©1994-2026 Bill Armintrout
Comments or corrections?

wardog26 May 2013 12:46 p.m. PST

guys
years ago I saw a picture of a ch47 Chinook hauling a underslung load consisting of a rubberised fuel tank
what I want to know is, does any one have specs and pictures of these fuel tanks in us or nato service as I am looking at modelling them for my games

Jemima Fawr26 May 2013 12:49 p.m. PST

They're commonly known as 'Bleeped text' (rhymes with 'rowlocks') in British service. I'll leave you to work out why…

picture

tuscaloosa26 May 2013 12:51 p.m. PST

Do a search for "fuel blivet", you'll turn up dozens of pictures of a great variety of sizes:

link

The nice thing in the field is, they are low tech. When the fuel pressure drops off, you just drive a jeep onto it for pressure.

Personal logo Doms Decals Sponsoring Member of TMP26 May 2013 12:54 p.m. PST


I'll leave you to work out why…

Judging from the picture, I think it's "because you have two pairs of them dangling below your chopper" – if so, I'd see a doctor ASAP….

Ironwolf26 May 2013 1:00 p.m. PST

All the fuel depots I saw in Iraq they were large flat and black. When full of fuel they were about 2 – 3 feet thick. Best way I could describe them was a large bladder.

hocklermp526 May 2013 1:24 p.m. PST

hobbylinc.com has them by Verlinden in 1/48 with a pumping unit and hoses. They are listed under Dioramas and are very detailed.

Gaz004527 May 2013 10:28 a.m. PST

They make a big splash when dropped off at altitude too………..a definite no smoking' one!

Fatman27 May 2013 4:29 p.m. PST

During the Falklands one of the navy Seakings tasked with resupply missions, after the loss of most of the heavy lift copters on Atlantic Conveyor, was labouring along carrying one Blivet in a sling. At this point the only Chinook blasted past with two underneath. The Seaking pilot radioed "____ing show of!"

"No old boy," Replied the Chinook pilot, "Showing of would be telling you we have another one inside!" ;-P

Fatman

Lion in the Stars27 May 2013 6:52 p.m. PST

Ah, love the Brit sense of humor…

link
Those are a LOT cheaper than I was expecting from Verlinden. Might need to buy a couple for an Infinity board I'm working on.

Apache 627 May 2013 9:16 p.m. PST

In USMC service, the 500 gallon ones are commonly used for Forward Arming and Refueling (FARP) sites or for short term storage at a refuel point. 10 blivets, various hoses and a pump (about 3' x 3' in a forkliftable cage) with 3 issue nozels is the standard set, but you'll see many other configurations.

20,000 gallon and 50,000 gallon bladders are used for either fuel or water in more permenant locations. Fuel bladders SHOULD ALWAYs be bermed.

wardog02 Jun 2013 1:55 p.m. PST

thanks guys

Sorry - only verified members can post on the forums.