"US Printers Using Projet 3500" Topic
6 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please do not use bad language on the forums.
For more information, see the TMP FAQ.
Back to the Sculpting Message Board Back to the Moldmaking and Casting Message Board
Areas of InterestGeneral
Featured Hobby News Article
Featured Link
Featured Showcase Article How to store and transport an army of giant apes?
Featured Workbench Article Need some trees for your wintery tabletop?
Featured Profile Article
Current Poll
Featured Book Review
|
| nothing | 09 Aug 2012 9:00 a.m. PST |
Looking for US based printing companies that use the Projet 3500 RealWax material. Any ideas? |
| CorSecEng | 09 Aug 2012 11:08 a.m. PST |
You could check with these guys. 3dwax.com/index.html Why do you need that specific model? EDIT: or just call these guys and ask. printin3d.com They either make the printer or distribute it. |
| nothing | 09 Aug 2012 8:12 p.m. PST |
Thanks CorSec. Technically I don't need that model, it's just the one I was reading about. I'd be happy with anything that does the same thing. |
| CorSecEng | 09 Aug 2012 9:11 p.m. PST |
I'm curious how the wax processes holds up against laser sintering. Problem is you loss the master if you try to cast it. Unless you can find an intermediate step that doesn't produce a lot of heat. |
| ancientsgamer | 10 Aug 2012 8:16 a.m. PST |
Lost wax casting. But the final master would be very rough ;-) |
| Pythagoras | 11 Aug 2012 12:04 p.m. PST |
In the lost wax process, you don't usually use the master. You make copies of the master and use those to make the pieces. |
|
reports from the final California Gen Con...