"Looking for 6mm Walls and Fences" Topic
6 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please use the Complaint button (!) to report problems on the forums.
For more information, see the TMP FAQ.
Back to the Modern Discussion (1946 to 2015) Message Board Back to the ACW Discussion Message Board Back to the WWII Discussion Message Board
Areas of InterestAmerican Civil War
World War Two on the Land
Modern
Featured Hobby News Article
Featured Link
Featured Ruleset
Featured Showcase Article Stingers in the Vietnam War?
Featured Book Review
|
Please sign in to your membership account, or, if you are not yet a member, please sign up for your free membership account.
| Cosmic Reset | 11 May 2008 10:33 a.m. PST |
Hello, I'm looking for a source for 6mm, 1/285, 1/300 walls and fences, preferably cast in metal. I'm aware of a couple sources, but am guessing there are more. Doea anyone have any suggestions? Thanks,
Brian |
| Baccus 6mm | 11 May 2008 12:09 p.m. PST |
I have a protoytpe for some metal split rail fencing going
through the master/pattern mould process at the moment. If all goes well it should be available in the next 2-3 weeks. I've gone this route because its impossible to find a good representation of this common form of American fencing in 6mm scale. Given that I'm about to release Polemos ACW rules I figured that it was down to me to rectify the situation. Cheers
Peter
|
| Stevus | 11 May 2008 12:58 p.m. PST |
well Irregular Miniatures are the obvious one. They tend to come in short lenghts (usually 5cm ish) but they have a fairly decent selection. Good detail and good value imo. Timecast sell some bits that might do. |
| Chris PzTp | 11 May 2008 1:06 p.m. PST |
C in C carries some link Though I'll be interesteed to see what Baccus comes out with. |
| Jedispice | 12 May 2008 12:39 p.m. PST |
|
|
